Step & direction or CW/CCW control
DSP-based stepper control technology
Anti resonance
Automatic motor identification and self configuration
Extra low noise
Extra smooth movement
Low drive & motor heating
Maximum frequency: 200KHz
Input voltage: 80 - 150 VAC / 113 - 212 VDC
Output current: 7 selections of 0.50 - 8.20A via DIP switches; or any value of 0.1-8.20A via software configuration
Micro steps: 15 selections of half - 128 step via DIP switches; or full - 512 step via software configuration
Automatic idle current reduction
Model:DM1182
Phase:2
Control Mode:Step & Direction
Max Input Frequency:200KHz
Input Voltage Range:80 - 150 VAC /
113 - 212 VDC
Output Current:0.50 - 8.20 A
Software Cofig. Resolution Range:200 - 102,400 (increased by 200)
# of DIP Switch Resolution Configurations:15
DIP Switch Resolution Setings:400, 800, 1600, 3200, 6400, 12800, 25600, 1000, 2000, 4000, 5000, 8000, 10000, 20000, 25000
Software Cofig Current Range:0.50 - 8.20A (increase by 0.1A)
# of DIP Switch Current Configurations:7
DIP Switch Current Configurations:2.2A, 3.2A, 4.2A, 5.3A, 6.2A, 7.2A, 8.2A
Logic Current Range:7-16mA (10mA typical)
Logic Voltage Range:4-5 VDC for pulse active high (default) , or 0-0.5V for pulse active low
Communication Type:RS232
Pulse enabled at:Rising edge
Idle Current Percentage:50 %
Software Config. Idle Current Percentage:0-100%
# of Digital Inputs:3
# of Digital Onputs:1
Step Width:2,500 ns
Minimal Direction Setup Time:5,000 ns
Protection:Over-current, over-voltage, under-voltage, phase-error, and over-temperature protection
Isolation Resistance:500M Ohm
Environment:Avoid dust, oil fog and corrosive gases
Ambient Temporature:0-50°C
Humidity:40–95% RH
Operating Temporature:0-70°C
Vibration:5.9 m/s2 Max
Storage Temporature:-20-65°C
Specification:7.87 X 5.39 X 3.19 Inches
Weight:2.86 lbs