10pcs/lot PWM to voltage 0-5V 0-10V duty ratio linear transmitter module DIY Signal conversion Board SC06

This is a linear conversion module, The output of PWM data is expressed by voltage signal through internal chip processing.

Module parameters:

the power supply voltage: 9V ~ 24V

the signal input voltage range: 4 ~ 24V

the input signal frequency range: 50Hz ~ 10KHz

the signal input duty cycle range: 0 ~ 100%

output voltage: 0.00V ~ 5.00V/0.00V ~ 10.00V

input: S1 pads on the circuit board: the default is open, there is no use to.

output mode: S2 pads on the circuit board: open circuit (output 0.00V ~ 5.00V); short circuit (output 0.00V ~ 10.00V), the default is open.

the scope of application: remote data acquisition and control equipment;

size: (L) 26mm (W) * * 23mm (high) 10mm

interface module:

24V: positive power supply interface (9V ~ 24V).

G: power supply interface.

IN: positive signal input interface.

G: a negative signal input interface.

OUT: signal output interface (0.00V ~ 5.00V/0.00V ~ 10.00V).

G: power supply interface.

Note:If output 0.00V ~ 10.00V, the power supply voltage must be 15 V.

Output (0.00V ~ 5.00V) resolution: 0.050V/D (V / dutycycle)

Output (0.00V ~ 10.00V) resolution: 0.100V/D (V / dutycycle)

Is used to calculate the duty ratio formula: (output voltage (V) / resolution) = duty ratio (%).

For example: output (0.00V ~ 5.00V) output for 2.5V

(2.5 (V) /0.05) = 50 (%).