Note:
It contains 3.175mm collet, if you need other specification collets, please contact us freely. thank you!
This motor is used widly by DIY users, high rotating speed and low noises, applicable to PCB engraver, acrylic, milling. etc.
Spindle Motor Specification:
Spindle motor: newest chroming brush DC motor
Working voltage:12-48VDC
Power: 400W
Speed: 3000-12000r/min (12V-3000r,24V-6000r,36V-9000r,48V-12000r)
Torque: 500mN.m
Insulation Resistance: >2 MΩ
Diameter: 52mm
Collet diameter: 16mm
Collet length: 43mm
Motor length: 185mm
Spindle motor weight: 0.9kg
Insulation dielectric strength: 400 v
Spindle accuracy: 0.01-0.04mm
Can be used for metal and non-metal engraving, wood carving, PCB drilling and so on
Air cooled spindle motor could be long time working
PWM DC Brush Motor Speed Governor Specification:
Applicable to DC12-60V low voltage PM brush DC motor
Working voltage: DC12V-DC60V(Max 65V)
Dimension: 75mm*75mm*42mm (include copper cylinder height 6mm)
Control Method:
1. Potentiometer(5K-100K available)default value 10K;
2. Analog 0-5V controlling(pull up XH2.54-3P potentiometer plug,signal line connect XH2.54-3P middle part,ground wire connect XH2.54-3P right part)
3. MACH3 terminals support add-in PWM signal input controlling speed regulation, add-in PWM input requirements:electrical level 3.5-12V VPP,frequency 1K-10KHZ,applicable to MACH3 spindle motor speed regulation controlling(add-in PWM signal controlling need to pull up XH2.54-3P potentiometer plug, otherwise, controlling is not available)
4. Rated current 10A, overload short-circuit protection current 12A
5. Soft starting function, avoiding motor and power supply damaged caused by motor suddenlly starting and overlarge current(default 0 seconds soft starting),0-5 seconds adjustable
6. Control power:12V120W、24V240W、36V360W、48V480W、60V600W
7. Pulse width modulation range: 0%-100%
8. This speed governor adopt humanized wiring terminals, very convenient wiring for users
Package List:
400W spindle motor*1
Collet*1
Speed governor*1